General
Two-colour status LEDs indicate the current status of the IPG.
LED “SYS”
The SYS LED indicates the current status of the IPG.
|
LED state |
Description |
|
Off |
IPG is out of operation. |
|
Blinking red |
IPG is in bootloader mode and a firmware update is being installed. |
|
Flashing red |
IPG is in an error state and is restarting. |
|
Steady red |
IPG is in bootloader mode. |
|
Flashing green |
IPG is operating normally. |
LED “LTE”
Indicates the status of the mobile network connection.
|
LED state |
Description |
|
Off |
LTE module is out of operation. |
|
Steady red |
Not registered in the mobile network. |
|
Flashing red |
Registered in the mobile network, but no data connection established. |
|
Flashing green |
Registered in a 4G network, data connection established. |
|
Blinking green |
Registered in a 4G network, data transmission active. |
|
Steady green |
VoLTE call in progress. |
|
Flashing orange |
Registered in a 2G network, data connection established. |
|
Blinking orange |
Registered in a 2G network, data transmission active. |
|
Steady orange |
2G call in progress. |
LED “PWR”
Indicates the status of the power supply.
|
LED state |
Description |
|
Off |
The IPG is not connected to the power supply. |
|
Steady red |
The battery is faulty, missing, or not connected. |
|
Flashing red |
Power supply failed; the battery is discharging and in a critical state. |
|
Flashing green |
The IPG is performing a battery test. |
|
Blinking green |
Power supply failed; the battery is discharging and in good condition. |
|
Steady green |
Power supply available and battery charged. |